Sheets & Plates

Grades: St37 – St44 – C45 – 42CrMo4 – S355JR – S355J2 – A285 – P325JH – etc
Thickness: 8mm – 150mm
Width: 1100mm – 4500mm
Length: 2500mm – 24000mm
Heat Treatment: Quenched &Tempered – Normalized

The production process of Rolled steels plates of this company includes the following specifications:

  • Reheating Furnace
  • Descaler System
  • Hi Reversing Mill Stand
  • Hydraulic Automatic Gap Control HAGC Max Roll Force KN(10000Tone)
  • X Ray machine *** During on-line rolling, it takes the thickness of the sheet continuously and sends its report to adjust the HAGC and control the thickness in the next pass of rolling, this equipment is placed after the stand.
  • Casting under argon gas to prevent contact of the melt with the surrounding atmosphere (Argon Protection Cover)
  • Gamma ray machine**This equipment is located after the X-Ray device, which in the last pass measures the length and width as well as the thickness in three points in a transverse profile and sends the report to Level 2 to control and correct the rolling process. This equipment is very advanced and unique in the region.
  • Hot Plate Leveler***The hot wedge gripper is located after the stand and the ACC system. The task of this equipment is to straighten the hot sheet from the waves resulting from rolling.
  • Testing Device Ultrasonic***This device is placed after the inspection table and before the trimming equipment. Its task is to detect internal defects including cracks, holes, etc. in the entire volume of the sheet. Based on the order and according to the standards desired by the customer, the sheet is tested

 

  • Side Trimmer & Slitting Shear
  • Leveler Cold***This equipment is located after Slitting Shear. The task of this equipment is to smooth the waves and small deformations resulting from cutting sheets up to 25mm thick. When the sheet passes through the Cold Leveler, the sheet becomes completely flat.
Order Now